75.5 mm IN/OUT Speaker Coil Till (Fiber)
- Inside and Outside copper windings Increases Surface Area thus increasing sound.
- Improves multi layer cooling.
Reference:
These Tweeter Coils are used in tweeter base of size 44.4 mm of 100watts.
Tweeters create high frequency sound but are smaller in size.
this device is used in tweeter speakers for high pitch sound eg feminine voice and many other related sound effects..
These Tweeter Coils are used in tweeter base of size 44.4 mm of 100watts.
Tweeters create high frequency sound but are smaller in size.
Uses 125 MM coil (Available on site search >electronics>coils )
18 inches 600 Watts 8 OHMS speaker.
A speaker is used to generate sound and radiate it into a room or open air.
Are connected to electrical sound devices to amplify the frequency of the sound depending on the watts of the speaker.
A speaker is used to generate sound and radiate it into a room or open air.
Are connected to electrical sound devices to amplify the frequency of the sound depending on the watts of the speaker.
The tweeters are kept in cars for allowing high frequency sound pitch in cars to feel the music much more effectively.
Uses 75.5 MM coil (Available on site search >electronics>coils )
15 inches 600 Watts 8 OHMS speaker.
A speaker is used to generate sound and radiate it into a room or open air.
Are connected to electrical sound devices to amplify the frequency of the sound depending on the watts of the speaker.
A speaker is used to generate sound and radiate it into a room or open air.
Are connected to electrical sound devices to amplify the frequency of the sound depending on the watts of the speaker.
PCB - Printed Circuit Board
Electrical connector used to connect speakers to amplifiers.
This crossover circuit is used as an electronic filter which splits signal in two or more frequency range.
Modern Digital Multimeter VICTOR brand.
A multimeter is an electronic device which is commonly used to measure the voltage , current and resistance.
Can be termed as Multi-tester or a Volt/Ohm Meter.
Tests continuity of two points in an Electric circuit.