Tweeter Base SG-34.4
This device is used to produce high frequency sounds and makes the sound more clear and authentic for the listener.
They have a big hole in the middle.
Used for P-Audio Tweeters.
This device is used to produce high frequency sounds and makes the sound more clear and authentic for the listener.
The purpose of the circuit is to increase (amplify) the input signal to produce output signal at a higher length than that of the input signal.
This is the main or port of an amplifier which controls and performs the function of Amplifiers.
Soldering Paste is a combination of powdered metal solder particles and a sticky flux (homey like consistency), when combined makes this paste into a thick paste compared to a putty (similar consistency like the way white cement paste looks like).
This device is used to increase the power of a signal.
Modern Digital Multimeter VOCTOR brand.
A multimeter is an electronic device which is commonly used to measure the voltage , current and resistance.
Can be termed as Multi-tester or a Volt/Ohm Meter.
Tests continuity of two points in an Electric circuit.
This crossover circuit is used as an electronic filter which splits signal in two or more frequency range.
Speakon are electrical connectors used in professional audio systems to connect loud speakers to amplifiers.
Two types of speakon available which are Female and Male.
This is a Wire which is connected to a Hand Blower.
Uses 65 MM coil (Available on site search >electronics>coils )
15 inches 600 Watts speaker.
A speaker is used to generate sound and radiate it into a room or open air.
Are connected to electrical sound devices to amplify the frequency of the sound depending on the watts of the speaker.
A speaker is used to generate sound and radiate it into a room or open air.
Are connected to electrical sound devices to amplify the frequency of the sound depending on the watts of the speaker.
PCB - Printed Circuit Board