Digital Amplifier
This device is used to increase the power of a signal.
This is Digital hence does not use an IC.
Reference:
This device is used to increase the power of a signal.
This is Digital hence does not use an IC.
This crossover circuit is used as an electronic filter which splits signal in two or more frequency range.
These are Electrical Connectors which are used to connect Speakers to Amplifiers.
PCB - Printed Circuit Board
A Megaphone is used to amplify a person`s voice to make it loud enough for peaple to hear who are far away .
Electrical connector used to connect speakers to amplifiers.
Electrical connector used for audio signals in microphones.
Uses 100MM coil (Available on site search >electonics>coils )
18 inches 1200 Watts speaker.
A speaker is used to generate sound and radiate it into a room or open air.
Are connected to electrical sound devices to amplify the frequency of the sound depending on the watts of the speaker.
A speaker is used to generate sound and radiate it into a room or open air.
Are connected to electrical sound devices to amplify the frequency of the sound depending on the watts of the speaker.
PCB - Printed Circuit Board
Modern Digital Multimeter VOCTOR brand.
A multimeter is an electronic device which is commonly used to measure the voltage , current and resistance.
Can be termed as Multi-tester or a Volt/Ohm Meter.
Tests continuity of two points in an Electric circuit.
This device is used to produce high frequency sounds and makes the sound more clear and authentic for the listener.