- Home
- Batteries add remove
-
Solar Prod
add remove
-
Electricals
add remove
-
Electronics
add remove
Crocodile Clip
add remove- Coils add remove
- Transistors and IC'S
- Speakers add remove
- Converters
- Glue
- Capacitors
- Diodes
- Computer Acc add remove
- CCTV Cam add remove
- Contact
100 mm IN/OUT Speaker Coil Till (Fiber)
Reference:
- Inside and Outside copper windings Increases Surface Area thus increasing sound.
- Improves multi layer cooling.
- Inside and Outside copper windings Increases Surface Area thus increasing sound.
- Improves multi layer cooling.
in the same category
Twitter Speaker Coils 44.4 MM
These Tweeter Coils are used in tweeter base of size 44.4 mm of 100watts.
Tweeters create high frequency sound but are smaller in size.
Horn Tweeter Cover NO.2B
- NO. 2B
- Flat Type
- 225mm by 225 mm
- 9 by 9 inches
- The product is used to cover tweeters
- Different types of covers are required in different sizes of tweeters.
Amplifier with IC TDA 7297
This device is used to increase the power of a signal.
Amplifier Circuit
The purpose of the circuit is to increase (amplify) the input signal to produce output signal at a higher length than that of the input signal.
Speaker Voice Coils 49mm - 58mm Tosha
Voice coils for speakers.
Magnifying Glass 60mm Lens
- Makes object to appear large
- Uses a Convex Lens
- Lens is 60mm magnifying power.
- Hand held Magnifyng Glass.
Piano Stand
- Supports a Piano during Musical Concerts or Occasions.
Speaker Terminal
An electrical connector for interconnecting Speakers and Amplifiers.
49.5 mm IN/OUT Speaker Coil Till (Fiber) Black...
- Inside and Outside copper windings Increases Surface Area thus increasing sound.
- Improves multi layer cooling.
- Black copper winding.
Temperature control Diode TF 200 (100/200/250...
- Has different Temperatures
- Available in following degrees > 100 Celsius, 200 Celsius and 250 Celsius.
- An electronic component which allows the flow of current in one direction.
- Converts voltage from AC to DC.
- Controls size of signal.
Horn Tweeter Cover NO.7
- NO. 7
- Flat Type
- 185mm by 185 mm
- 7.5 by 7.5 inches
- The product is used to cover tweeters
- Different types of covers are required in different sizes of tweeters.
Speaker Terminals
Electrical connector used to connect speakers to amplifiers.
Multimeter UT33B+
Modern Digital Multimeter UNI-T brand.
A multimeter is an electronic device which is commonly used to measure the voltage , current and resistance.
Can be termed as Multi-tester or a Volt/Ohm Meter.
Tests continuity of two points in an Electric circuit.
IRFZ 44
- Operating temperature at 175 degrees Celsius
- Switching high power devices
- Controls speed of motor
- LED Dimmers or Flashers
- Semi-conductor device
- Amplifies or switches electronic signals and electrical power.
- Regulates Current
Bond Tite Metallic 36gms
- 4 Minutes Metal Filled Epoxy Glue4
- Fast setting
- Can be drillled
- Metal Filled Non corrosive
- Can be Sanded and Painted
Bolt Type Diode 50 Amps
- An electronic component which allows the flow of current in one direction.
- Rectifies voltage from AC to DC.
- Controls size of signal.
Speakon Female Type 1
Speakon are electrical connectors used in professional audio systems to connect loud speakers to amplifiers.
Two types of speakon available which are Female and Male.
2200uF 35V
- Electrolytic Capacitors
- Leaded
- Made of high Quality Components to give long Service Life
- Low Interruption
- Max Temp 85 degrees celcius
Horn Speaker 100 W
- Allows better communication through the air by improving the coupling efficiency of the speaker drive
- 100 w