Canon Pin Male and Female
Electrical connector used for audio signals in microphones.
Reference:
The purpose of the circuit is to increase (amplify) the input signal to produce output signal at a higher length than that of the input signal.
This circuits are used in Amplifiers to allow the amplifier to perform its function ..
The purpose of the circuit is to increase (amplify) the input signal to produce output signal at a higher length than that of the input signal.
Electrical connector used for audio signals in microphones.
PCB - Printed Circuit Board
Voice coils for speakers.
Uses 100MM coil (Available on site search >electonics>coils )
18 inches 1200 Watts speaker.
A speaker is used to generate sound and radiate it into a room or open air.
Are connected to electrical sound devices to amplify the frequency of the sound depending on the watts of the speaker.
A speaker is used to generate sound and radiate it into a room or open air.
Are connected to electrical sound devices to amplify the frequency of the sound depending on the watts of the speaker.
PCB - Printed Circuit Board
Special type of Loudspeaker that produces high frequency audio in a kind of a tweet sharp sound as birds make .
This paste is made of a combination of zinc oxide and silicone thus charecterised to have a high thermal conductivity
An electrical connector for interconnecting Speakers and Amplifiers.
2 RCA Female input 1 RCA Male Output
RCA means (Radio Corporation of America).
An electrical connector used to carry audio or video signals.
Modern Digital Multimeter UNI-T brand.
A multimeter is an electronic device which is commonly used to measure the voltage , current and resistance.
Can be termed as Multi-tester or a Volt/Ohm Meter.
Tests continuity of two points in an Electric circuit.
PCB - Printed Circuit Board
A set of drums which has drum sticks, bass drum,floor tom,tom rack and a snare drum, crash cymbal and a Hi-Hat.