Reference:
Canon connectors used in professional audio systems to connect to micro phones.
Available in male and female.
The purpose of the circuit is to increase (amplify) the input signal to produce output signal at a higher length than that of the input signal.
The purpose of the circuit is to increase (amplify) the input signal to produce output signal at a higher length than that of the input signal.
This device is used to increase the power of a signal.
This is Digital hence does not use an IC.
Digital Clamp Meter.
A multimeter is an electronic device which is commonly used to measure the voltage , current and resistance.
Can be termed as Multi-tester or a Volt/Ohm Meter.
Tests continuity of two points in an Electric circuit.
Electrical connector used to connect speakers to amplifiers.
Most commonly used in Modern Piano.
These are Electrical Connectors which are used to connect Speakers to Amplifiers.
2 RCA Female input 1 RCA Male Output
RCA means (Radio Corporation of America).
An electrical connector used to carry audio or video signals.
Quality TOSHA Speakers Assembled Locally.
Uses 75.5MM coil (Available on site search >electonics>coils )
15 inches 900 Watts speaker.
A speaker is used to generate sound and radiate it into a room or open air.
Are connected to electrical sound devices to amplify the frequency of the sound depending on the watts of the speaker.
A speaker is used to generate sound and radiate it into a room or open air.
Are connected to electrical sound devices to amplify the frequency of the sound depending on the watts of the speaker.
A device made of Conductive Metal sends or intercepts Electro-magnetic waves.
Helps in sending and receiving information via certain devices.
